B-sim and blowview for PET bottle ISBM simulation

[fshi010]

Dear All,

As for the process simulation of ISBM PET bottle, there are few commercialized software to be selected. So far I found that there are two, one is B-sim from Accuform; the other is from IMI of CNRC.

for both softare, KBKZ constitutive model is applied. Now I'd like to evaluate them. Have anyone used the two softwares? Could you give me some suggestions.
thanks in advance.


Simon

[Jorgen]

I have not used either of those FE packages (yet).

Perhaps someone else can provide more info...

-Jorgen

[fshi010]

Hi, Jorgen,

Actually I have found one article about this evaluation and this article, " A comparative study of simulation softwares for stretch blow moulding", is from ANTEC 2007 sponsored by SPE.

Unluckly, I am not the member of SPE, so i cannot get the full paper.

Any one can help me download this paper? Thanks a lot in advance.


Simon

[Jorgen]

If you send me a private message with your email then I'll see what I can do.

-Jorgen

[fshi010]

If you send me a private message with your email then I'll see what I can do.

-Jorgen

Dear Jorgen,


Really thanks a lot and I have received the paper you sent to me.

Best regards,
Simon

[tom zhou]

[QUOTE=Jorgen;3703]If you send me a private message with your email then I'll see what I can do.
Hi, Jorgen

I am a newcomer of PolymerFEM and i saw the left message by simon about this paper "A comparative study of simulation softwares for stretch blow moulding", is from ANTEC 2007 sponsored by SPE.

I am either a member of SPE and i also need this paper, can you help me download it?

I will be thankful very much.

best regards.

tom zhou from China

my email:zhouji120@sjtu.edu.cn