PP Abaqus

[artemioalanis]

I just started using abaqus and i'm concerned with the behavior of my desing. I'm basically doing a simple Static non linear test on a block of polyprophylene and i have these material characteristics.

Elastic Modulus: 1300 N/mm2
Tensile Strength: 37 N/mm2
Density: 9 e-10 Tons/mm3
Possion: 0.41

Is this enough to simulate a good behavior for polyprophylene ?

Thanks for your help.

[Jorgen]

That information is very limited, and will only give good predictions in some very specific limited situations.
What are you trying to do?

-Jorgen

[artemioalanis]

i've already added a creep test data to take into account the viscoelastic properties
i ran a simple static test just a pp structure with a load