amar
2004-06-23, 09:35
Hello,
This is my first post on the website so I apologise if I make any mistakes.I am doing a riveting analysis in ABAQUS/standard. It has two aluminum plates joined together by an standard aluminum rivet. It involves large deformations and plasticity.
Now, I want to introduce a sealant in between the two plates. I want to model the sealant as an elastomeric material using hyperelastic material. Since the rivet will compress the plates I want compressive stress strain data. I dont have that but I had gone through the abaqus examples problems and they have constants (Mooney rivlin etc.) fitted for rubber gaskets etc. I was thinking of using those.
Also, this website also has lot of data for uniaxial compression for different rubber materials. The data is given for different strain rates. If I use that data do I input a sepcific strain rate data in abaqus? or do I have to input data at all three strain rates? Is the data suitable for my analysis?
Since purpose of sealant is to seal the plates do I use regular contact in abaqus or do I use Tie constraints for adhseive and plates?
Any suggestions, help will be greatly appreciated. Thanking you ina dvance.
Amar Atre
Student
Gatech
This is my first post on the website so I apologise if I make any mistakes.I am doing a riveting analysis in ABAQUS/standard. It has two aluminum plates joined together by an standard aluminum rivet. It involves large deformations and plasticity.
Now, I want to introduce a sealant in between the two plates. I want to model the sealant as an elastomeric material using hyperelastic material. Since the rivet will compress the plates I want compressive stress strain data. I dont have that but I had gone through the abaqus examples problems and they have constants (Mooney rivlin etc.) fitted for rubber gaskets etc. I was thinking of using those.
Also, this website also has lot of data for uniaxial compression for different rubber materials. The data is given for different strain rates. If I use that data do I input a sepcific strain rate data in abaqus? or do I have to input data at all three strain rates? Is the data suitable for my analysis?
Since purpose of sealant is to seal the plates do I use regular contact in abaqus or do I use Tie constraints for adhseive and plates?
Any suggestions, help will be greatly appreciated. Thanking you ina dvance.
Amar Atre
Student
Gatech