narender
2007-10-10, 05:35
hi sir,
my aim is to model the spring system between nodes of shaft element and housing of the bearing.i could not able to select the nodal points on both the surfaces.please give the procedure to select the nodes and conneting the spring element between those nodes in abaqus.
thanking u sir....
yours faithfully
narender
iit delhi
post graduate student
my aim is to model the spring system between nodes of shaft element and housing of the bearing.i could not able to select the nodal points on both the surfaces.please give the procedure to select the nodes and conneting the spring element between those nodes in abaqus.
thanking u sir....
yours faithfully
narender
iit delhi
post graduate student